Built in Tiruchengode, India · Supplying India, Africa and export markets
Equipment Selection

Choosing a Core Drilling Rig: Depth, Core Size and Wireline

Core drilling recovers a continuous cylinder of rock that geologists and engineers can log and test. Choosing the rig means matching core size and depth to the pull-up, rotation speed and winch capacity the rig can provide.

Core Drillings
Key takeaways
  • Core size and depth together set the rig size: HQ capacity is always lower than NQ.
  • Wireline winch length should exceed your deepest hole.
  • Mobility matters as much as capacity on exploration programmes with many short holes.

Core size changes everything

NQ core is about 47.6 mm in diameter; HQ is larger. A rig rated for 300 m in NQ will usually reach only around two-thirds of that in HQ, because the heavier rods and larger bit need more pull-up and torque. Our CDR-300, for example, is published for NQ to 300 m and HQ to 200 m.

Match depth to pull-up and power

Pull-up force must lift the full rod string plus friction. Across the CDR series, published pull-up rises from 5,400 kg (CDR-50) to 24,000 kg (CDR-2000), and prime movers from 76 HP to 320 HP. Choose a rig with headroom over your deepest planned hole.

Rotation speed and torque

Diamond bits cut best at high speed in hard rock, while larger diameters and broken ground need torque. The CDR rigs publish speeds up to 1,000–1,200 rpm with torque ranges up to 1,350 kg·m on the CDR-2000.

Wireline or conventional?

With wireline coring, the inner tube and core are pulled up inside the rods on a wire, so the rod string stays in the hole. It saves a lot of time on deeper holes. The wireline winch should hold more rope than your deepest hole: from 75 m on the CDR-50 to 2,100 m on the CDR-2000.

Mud pump, mounting and site moves

Core rigs need a reliable water or mud pump; the CDR series lists a hydraulic triplex pump at 140 lpm and 1,000 psi. For programmes with many shallow holes on farmland or tracks, a tractor-mounted rig such as the TC-40 can move faster between collars.

Questions

What is the difference between NQ and HQ?

They are standard core sizes. HQ produces a larger core than NQ (about 47.6 mm) and needs more rig capacity for the same depth.

Which rig for 500 m NQ holes?

The CDR-500 is published for NQ to 500 m and HQ to 300 m. For regular holes near 500 m, consider the CDR-1000 for headroom.

Can a core rig also do geotechnical work?

Yes. Smaller rigs such as the CDR-50 and CDR-150 are often used for site-investigation coring.

Continue reading

More drilling guides

All guides
Start the conversation

Tell us about the hole you need to drill.

Share the depth, diameter, formation and site access you know. We will come back with the rig, tooling and package worth discussing.